Trouble-shooting For Diamond Tile Drills
Most common issues occur as a result of the following:
- Drilling in hammer mode
- Incorrect use of diamond tile drill
- Using an incorrect drill motor for diamond drilling
- Machinery fatigue, wear or faults
- Incorrect fitting on machinery
Common Issues and Causes
1.Poor Performance / Cracked or Broken Tiles
Possible Causes:
- Machine being used is under powered.
- Drive direction on machine is set to reverse.
- Drilling in hammer action mode.
- Excessive pressure being applied during use.
2.Drill Bits Overheating
Possible Causes:
- Tile debris lodged inside the barrel.
- Tile dust clogging the wax filled barrel.
- Excessive pressure being applied.
- Not periodically removing the bit from the hole to allow for cooling.
3.Reduced Lifespan
Possible Causes:
- Excessive pressure being applied during use.
- Drilling rather than milling – Let the drill bit do the work!
- Drilling into the material behind the tile.
- Inappropriate or faulty machine being used.
- Incorrect fitting.
- Not allowing the drill bit to periodically cooldown.
- Tile debris or waste material clogging the barrel.
If You Have Further Requirements
Leave your request online and we will respond promptly!
Copyright © Henan Pinnacle Superhard Materials Co., Ltd
Powered by :www.300.cn Supported IPV6 Privacy Agreement